The
Tyent
Citric Acid Ionizer Cleaning Cartridge is a MUST HAVE in areas with
hard water! In fact even if your water is not particularly hard it
is recommended that you use the cleaning cartridge at least once
every year. Why? Have you ever used a pot to boil water over
and over without washing it? What occurs? A white film begins to
build up. Well, this same water is running through your machine and
the electrolysis plates your machine works by attracting the calcium
and magnesium in your water to itself so it can be ionized. This
process will inevitably lead to a build up of calcium on the
electrolysis plates just like what you see in that pot. What does
this do? This scale build up forms a barrier between the water and
the electrolysis plate thereby reducing the effect of the
ionization. As this scale accumulates on plates your machine will
not be able to make the same quality alkaline water as when you just
bought it. If this continues and your Tyent MMP Water ionizer is not
cleaned it will have trouble making alkaline water and even worse
the calcium build up could get hardened over time making it even
harder for the cleaning cartridge to work.
Using
the Tyent Cleaning Cartridge will work to prevent problems like this
and help to keep your Tyent water ionizer running like new,
producing high alkaline and potent anti-oxidant water (with high ORP
values).
The
Tyent Citric Acid Ionizer Cleaning Cartridge expires after ONE use! Please
make sure to follow the step-by-step directions below to ensure
proper usage and prevent any damage to your ionizer:
Directions For Use:
Note: Read all instructions
before you start. When cleaning machine with TYENT CLEANING FILTER,
be sure to always use the H2O purified water setting level only, DO
NOT USE ANY OTHER LEVEL while cleaning or damage could occur.
1) Shut off the water supply going to the
unit
2) Locate the filter housing of your ionizer and remove the 2nd
Filter (with green label) by rotating it clockwise (the filter to the right when
looking at the back of the unit)
3) For the MMP
models attach the Citric Acid Ionizer Cleaning Cartridge by rotating the
cartridge clockwise, and for the Tyent UCE-9000T or (HI series)
rotate cartridge counterclockwise. Do NOT over tighten. Please
be careful to purchase the correct cleaning cartridge for your
particular ionizer.
4) Run water through the ionizer using the H20 CLEAN mode for 5 minutes and
stop. DO NOT
use any other mode when going through this cleaning process!
5) Leave machine for 3
hours. Let everyone know that the machine is being cleaned and no
one should touch it.
6) After 3 hours has
elapsed run unit on the H2O mode for 5 minutes then stop.
7) Remove the Citric Acid Ionizer Cleaning Cartridge
and replace it with the filter #2.
8) Run the unit on H2O mode for 3 minutes.